What is Hot melt glue gun?
Hot melt adhesive gun is a kind of decoration tool, which is widely used in hot melt adhesive strip bonding products such as electronic factory, food factory, packaging factory and so on.
Usage of hot melt glue gun:
1. Before inserting the hot melt gun into the power supply, please check whether the power cord is intact and whether the support is ready; Whether the used glue gun has glue pouring and other phenomena.
2. Please preheat the glue gun for 3-5 minutes before use. Please stand upright on the table when the glue gun is not in use.
3. Please keep the surface of the hot melt adhesive strip clean to prevent impurities from blocking the gun nozzle.
4. If the glue gun fails to produce glue during use, please check whether the glue gun is hot.
If the glue gun cannot generate heat normally, the reason may be:
1. The glue gun power supply is not plugged in properly.
2. The glue gun was burnt out due to short circuit.
3. If the nozzle is blocked by impurities, please ask professional personnel to deal with it;hot melt glue guns.
4. The glue gun pours the glue to make the rubber strip thicker. At this time, just rotate the rubber strip slightly for one week, carefully pull out a small part backward, peel off the thicker part of the rubber strip, and then continue to use.
5. Avoid using sol gun in humid environment. Humidity will affect insulation performance and may cause electric shock.
6. The nozzle and glue melt are very high temperature (about 200 degrees). Do not touch other parts except the handle.
7. Do not pull out the adhesive strip from the glue inlet. Hot melt adhesive will cause serious burns or damage to the glue gun.
8. Do not disassemble and install the electric heating parts at will, otherwise it will cause failure.
9. Keep out of the reach of small children and store away from them.
10. It shall not be used for any purpose other than glue melting.
11. If the glue strip in the glue gun has backflow, please stop using it immediately and use it only after the professionals have cleaned the backflow hot melt glue.
12. The glue gun is heated continuously for more than 15 minutes. If it is not used, please cut off the power supply.
Copyright © 2021 NINGBO FBELE ELECTRONICS CO.,LTD. All Right Resrved Designed by www.followala.com
Welcome to text me on WhatsApp or send me an email to sales@fbelec.com